Manual Motion Control

1. Turn the power on by a switch on rear panel, if needed.
2. Turn the fron panel switch from REMOTE to LOCAL
3. Turn the motor current on by a switch on the front panel.
4. Press C and ENTER to get the COMMAND PAGE on the display.
5. Press TAB to move the cursor to "A"("B") to select the motor "A"("B").
   Select NORMAL (OFF) by pressing +/- to turn on (off) the motor current.
   To set the chosen condition on the motor, press ENTER.
6. Press A (B) and ENTER to select page A (B).
   Note: "A" and "B" refer to the upper and lower connectors on the rear panel.
7. Press TAB to show the cursor at COMMAND.
   The number under POSITN indicates the current position of the motor.
8. Press +/- to select the type of the motion among GO-->POSITION, GO-->L1 and GO-->L2.
   Note: L1 and L2 are the limit switches.
9. When you press ENTER for GO-->L1 or GO-->L2, the motor starts moving.
10. If GO-->POSITION is selected, pressing ENTER moves the cursor to POSITION.
11. Set the number on the number key for the desired final position of the motor.
12. Press ENTER to start the motor.
13. To stop the motor before the position count is met, move the cursor to COMMAND by pressing TAB, then select STOP by pressing +/-.
14. Press ENTER to execute STOP.

Motion Controls Data Table

Last updated by C. Newsom at 17:00 May 29, 2003