Getting PWC plots going

• If ACNET is not up, click on 'Start ACNet'
• If the S45 screen is not up, type S45 in the extreme upper left corner of the screen, then hit ENTER.
• If the MESON page is not selected, then go to the drop down menus across the top of the page and select 'MESON' from the first one.
• A list of meson PWCs will appear on the screen. Click on the names of any you wish to see. There are 3 MT6 pwcs. An asterisk will appear next to the names of the selected planes.
• Click on the 'Start Plot' command.
• Choose the 'Plot' command. A list of the default options will appear. Change any that are not as follows:
  • Continuous
  • Relative to center (Absolute)
  • Both Planes
  • Both Planes
  • Autoscale (Positive)
  • SA_slot [This can be SA, SB or SC screens]
  • Hardware Fit