ACNET/Motion Controllers for dummies (under construction)

ACNET/Motion Controllers for dummies

Magnet controls
1. Find an ACNET terminal
2. If ACNET is not running:Click on the starup button.
3. Click on the Utilities button at the bottom of the termanal screen.
4. Select Enable on the page which appears. This will enable remote control for one hour.
5. Minimize the utilities page
Motion Controller
1. Find an ACNET terminal
2. If ACNET is not running:Click on the starup button.
3. In the upper left hand corner you will see a capital letter representing the current location. Move the cursor over it and overtype the letters "S17" and hit "enter".
4. On line 4 at the top left of the screen you will see the page number written as follows "-<1>+". Change the page number to "4" and hit "enter".
5. You are now on the Meson Motion Controller page
6. You can enter settings into the D/A column to change the positions.
7. By selecting the dots to the right of each line you can get the status of the device. It will create a status button which you can click to get that devices status page.
Stuck motion control motor(motor steps are changing but motor is not moving)
1. Go to rack RR04 in the rack room
2. Find the black controller for the motor which is stuck.
3. Power cycle by using the power on/off switch on back.
4. Follow the turn on procedure.